Mobile

Distribution transactions

Distribution methods and direct trading

Regarding direct trading, for the LPS01 series, please refer to the distribution conditions.
The PSM01/PSM02 series is also described below, as we intend to focus mainly on direct transactions in the future.

  • The order production system is based on pre-payment
    After confirming payment, we will arrange parts and materials as necessary.
  • The remittance method will be bank transfer or PayPal remittance.
  • We only ship within Japan.
    If you are outside Japan, please use a forwarding service.
  • Please allow approximately one to two week for the PSM01/PSM02 series and three to four weeks for the LPS01 series.
    If the board is not in stock, we will place an order, so please allow another week or so.
    We will reply to you including the delivery date when you contact us.
  • For direct transactions, please contact us using the contact form.

This is a hobby distribution by an individual, so the above methods are the only way to distribute the products.

We would be grateful for your understanding.

Please note that if we confirm resale, we will stop distribution or distribute at the resold price.

About PSM01/02 customised products

For PSM01 and PSM02, changes of capacitors and DC cable lengths can be made through direct transactions.
Please state this in your enquiry and we will do our best to accommodate you.
However, if the capacitor is difficult to obtain, the user will have to obtain it himself and send it to us.

Example.

  • I want B2N in PSM01

  • I want BN/BP in PSM02

  • I want the DC cable length to be 30 cm / covered with heat shrink tube

  • I want PSM boards covered with heat shrink tubing（+500 Japanese Yen /1 unit)

  • I want the DC plug to be the specified one

Basically, the cost of the parts and the shipping costs of purchasing the parts are covered by the cost of the parts,
For covering PSM boards with heat shrink tubing,

  • Cost of purchasing a professional heat gun
  • Cost of large-diameter heat-shrink tubing + shipping costs

Please note that the cost of the separate equipment is divided and taken into account.

Supported voltages for LPS01

The basic specification of the LPS01 is 5V/9V/12V/15V, with the choice of two close voltages, but custom voltages are also available.

Example.

  • To support the NU-DDC of AUSE, a 5V/6V specification with 5-8V voltage adjustment and a secondary filter configuration of 3 UKAs + 2 MUSE UKZs.
    (This is the current LPS01 5V/6V configuration for NU-DDC.)

This will also be supported if you mention this when making an enquiry.